Atlanta FM Amateur Frequencies



Paul's Ham Radio Links



My Ham Shack


Atlanta FM Ham Frequencies


Callsign Contacts


Ham Radio Links



Email Me!


Ham Homepage


Paul's Frequencies


AM Broadcast Band


Shortwave


FM Broadcast Band


Aircraft Freqs


Public & Trunking Frequencies


XM Satellite Radio



Ham Homepage


Email Me!


Paul's Ham Radio Links



My Ham Shack


Atlanta FM Ham Frequencies


Callsign Contacts


Ham Radio Links



Ham Homepage


Email Me!


Paul's Ham Radio Links



My Ham Shack


Atlanta FM Ham Frequencies


Callsign Contacts


Ham Radio Links

On this page I listed the known working repeaters in the NW Atlanta Area, and some common other freqencies for each individual band (such as simplex frequencies). For those new to ham radio, what a repeater does is retransmit the audio input coming in on one frequency and it broadcasts it out on another frequency. Repeaters are usually placed in relatively high areas, such as mountian tops or building tops, which allows longer communication than just simplex (or 2-way). The list for each band shows the repeater output frequency with either a "+" or "-" next to it that corresponds to whether the input frequency is either above or below the output frequency by the band's designated offset. For example on the 2-Meter band the offset is 600 kHz, so if the frequency listed is 146.880- then the input frequency would then be 146.280. To the right of that, P.L. Tone frequencies are listed if used and the Callsign and organization sponsoring repeater if known. For people with the scanners, the ham frequencies listed below should be programmed so you can monitor the communications between ham operators. Some conversations will be technical, some uneventful, but during disasters, some extremely important and informative. Individual bands have their own special features, and offsets, so information is given in each area..



6-Meter Amateur Frequencies (50-54 MHz)

The 6-Meter band is used for serveral modes from FM to USB for transmission. When conditions are right, the 6-Meter band carries on some of the propagation conditions of the HF bands, allowing nationwide and sometimes overseas contacts. When propagation conditions are low, little activity may be found on this band.

Standard Offset: Varies, but usually 1.0 MHz

National Simplex Frequency: 52.525 MHz
USB Simplex Frequency: 50.125 USB MHz

Following is a list of Known Working Repeaters:


2-Meter Amateur Frequencies (144-148 MHz)

The 2-Meter band is the most commonly active ham band used for local communication, and by far contains the most activity in the Atlanta area. In evenings, sometimes I can receive audio from repeaters in Alabama and Mississippi, but can't respond to them because of the atmospheric conditions.

Standard Offset: + or - 600 kHz

National Simplex Frequency: 146.52
Other Simplex Frequencies: 146.550, 147.450, 147.525, 147.570, and More.

Following is a list of Known Working Repeaters:


220 - MHz Amateur Frequencies (222-225 MHz)

Many say the 220-MHz band contains the best of both worlds. The good coverage of the 2-Meter band and the higher audio fidelity that the 440-MHz band offers. Currently, the only radio I own capable of transmission on 220-MHz is the Yaesu VX-7R, which is only rated at 300mW output power on this band.. This is the reason for the limited repeater listings.

Standard Offset: 1.600 MHz

National Simplex Frequency: 223.500 MHz
Other Simplex Frequencies:
223.400 MHz, 223.420 MHz, 223.540 MHz, and More.

Following is a list of Known Working Repeaters:


440 - MHz Amateur Frequencies (420-450 MHz)

The 440-MHz band offers the highest audio fidelity of all these covered bands. I can tell a big difference, so when both parties have 440 bands on their radios, I choose to use those repeaters or simplex frequencies. The 440-MHz band is also offered on many dual band handi-Talkies and mobile rigs which gives it more activity than the 6-Meter and 220-MHz bands. Mobile rigs, although, require 2-Meter/440 combo antennas which can cost extra, so few use the 440 band. Many hams try to make an effort to use the 440 band to prevent the loss of it by the FCC towards other spectrum needs (Like what already happened to part of the 220 band).

Standard Offset: 5.0 MHz

National Simplex Frequency: 446.00 MHz
Other Simplex Frequencies:
445.825 MHz, 445.875 MHz, 446.025 MHz, and More.

Following is a list of Known Working Repeaters:


Am I Missing a Repeater, Frequency or P.L. Tone?
Email Me with the Details!


Well that's the list of known Atlanta Region Repeaters. If your a ham in Atlanta program some of these into your radio and give them a try. If you not a ham program these into your scanner and listen. You may just want to become a licensed operator one day!!

Have Fun!!...73..

Paul J. Lossner
KE4NFU


Amateur Radio Links
Ham Homepage | Email Me!
My Ham Shack | Atlanta FM Ham Frequencies | Callsign Contacts | Ham Band Openings | Ham Radio Webpage Links


Broadcast Radio Links
Ham Homepage | Email Me!
AM Broadcast Band | Shortwave | FM Broadcast Band | Aircraft Band | Public & Trunking Frequencies | Television Stations | XM Satellite Radio



WEBMASTER
p.j. WebGraphics - Marietta, Georgia

p.j. Webgraphics

© 2002 Paul Lossner

All Rights Reserved. Unauthorized redistribution of this document is prohibited. Opinions expressed herein are those of the authors, not the Internet Service Provider.

Web Hosting Provided by iPowerWeb.